![]() With the bootloader pins jumped, and your board and firmware version already selected, plug in the FC and it should automatically flash. ![]() I believe I checked no reboot sequence, full chip erase and flash on connect. Ive punched all the buttons mentioned above, but after 12 dozen tries, all that comes up is No response from bootloader. I tried to follow your directions, but there are some boxes to check and I dont know if I should check them. You will need to update your settings, and if this is a board like mine, you will have to plug a flight pack into it because the stop motor will not be on and on mine, the motors want to spin under USB power. ![]() You can try different parameters but I would start with those. Select your board and version, I had mine set to flash on power as well as 256000 and clean install. So, you are saying, go right to Betaflight and try and flash it Should I leave the boot pins jumped during this attempt. Yes, the FC is powered the whole time because its attached to the computer. You are jumping the boot pins, then powering the FC and leaving it powered the whole time If so, you may have one of those boards like I had on a 110 quad where it would absolutely NOT go into DFU mode, but if you went ahead and flashed it, it would work.īut again, no DFU mode, no STM Bootloader, but just try to update the firmware. ![]() Second thing, make sure you have clicked options Show All Devices in order to see the STM Bootloader. If this is not done, it will not show the STM Bootloader in Zadig. Or a way to bypass this and still end up where I need to be with Betaflight. ![]() Is there a way to get the Bootloader on the devices list on Zadig. I think Im doing most of it right, but Im stuck because on the options list on Zadig doesnt show STM32 Bootloader. Trying to follow the directions from several Youtube videos about this process. Did you know Registration is FREE and is only a couple clicks away You can even sign in from Facebook, Twitter or Google for your convenience So what are you waiting for, CLICK HERE to join in on the conversation. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |